EasyManua.ls Logo

Autel Robotics EVO - Page 16

Autel Robotics EVO
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Additional Functions
The smart functions listed below will give you a full understanding of the aircraft
battery and how to protect and preserve the battery life.
Storage Self-Discharge Protection: In order to prevent damage, after the
battery has been idle for 6 days and the voltage is higher than 12V, the battery
will discharge automatically to approximately 70% of total power. This is the
default setting, and the discharge process takes 2-3 days. While there’s no
formal indication that the battery is performing a self-discharge cycle, you
may notice a slight warming of the battery, which is normal. The discharge
threshold can be customized using the Autel Explorer
TM
app.
Charging Temperature Detection: The normal charging temperature should
be between 10°C (50°F) and 45°C (113°F), the battery will stop charging if the
temperature exceeds this range.
Overcurrent Protection: The battery will stop charging if the charging current
exceeds 8A to prevent severe damage.
Overcharge Protection: Charging will stop automatically when the battery
reaches full charge.
Balance Protection: Balances the voltage of each battery cell to prevent
overcharging or over-discharging.
Over-Discharge Protection: When the battery is not in use, it will
automatically disconnect the power output function once the self-discharge
cycle is completed. This function is disabled during ight.
Short Circuit Protection: The power supply will be cut off in the event that a
short circuit is detected.
Power Saving Mode: After 30 minutes of inactivity, the battery will disconnect
from the power supply and enter power saving mode to retain the energy.
Communication: When in use, the aircraft continuously syncs with the
battery to provide real-time information including voltage, capacity, current,
and temperature.
Ultra-Low Power Consumption Mode: When idle for 7 days with a voltage
lower than 11.7V, the battery will enter this mode in order to conserve power.
It will resume normal function after being connected to the charger.

Related product manuals