Autel Robotics EVO - Chapter 3 Preflight Preparation; Battery Preparation; Aircraft Battery Installation; Aircraft Battery Removal

24
Chapter 3
Preight Preparation
EVO features a user-friendly design and comes fully assembled out of the box. In
order to ensure safe drone operation, please read and understand the instructions
and warnings below before your rst ight.
3.1 Battery Preparation
3.1.1 Aircraft Battery Installation
1. Power off the battery before installing it.
2. Insert the battery into the battery
compartment as shown on the right.
3. The battery will rmly click in place.
3.1.2 Aircraft Battery Removal
1. Power off the aircraft battery before
removal.
2. Press and hold the top button ( )
located on the battery and pull it out
slowly.
3.1.3 Charging
The aircraft battery and remote control can be charged simultaneously using the
supplied charger. There are two connectors attached to the charger’s adapter
block. As shown below, the xed one goes with the aircraft battery, and the USB
cable is used to charge the remote control.