EasyManua.ls Logo

Autel Robotics EVO - Troubleshooting Tips

Autel Robotics EVO
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
40
IMPORTANT
• The upgrade takes about 15 minutes. Don’t turn off EVO or the remote
control, or remove your SD card from the camera during the process.
Do not start the motors.
• After upgrading, the remote control may be disconnected from the
aircraft. If you need to pair them again, see Section 3.2.4: Aircraft &
Remote Control Preparation ( 28 ).
5.2 Troubleshooting Tips
Q1. If EVO indicates a failure during self-check (Rear LED Indicators will
turn solid red):
• Hardware problems detected, contact the Customer Service:
• www.autelrobotics.com/contact-us/
Q2. If the motors fail to start up:
• Verify the remote control and the aircraft are paired
• Check the remote control to make sure it’s calibrated correctly
• Verify the aircraft battery level
• Make sure the compass is calibrated correctly
• Make sure GPS is available (if Novice Mode is active)
Q3. If takeoff fails after starting motors:
• Double-check that EVO is not in a known no-y zone
• Make sure the aircraft is on a at, level surface
Q4. If ight time is preemptively reduced:
• The most common cause of reduced ight time is a low temperature in the
operating environment or increased takeoff weight
Q5. If EVO does not respond to the remote control during the pairing
process:
• Make sure there are no metal objects, mobile devices or other remote controls
nearby
Q6. If Video Link fails or disconnects frequently:
• Double-check that both EVO and the remote control are free from sources of
magnetic or signal interference
Q7. If the camera is powered off during while recording video: