9
3 Getting Started
Ensure the tool is connected to the Internet and is sufficiently charged
(See Power Sources). The product should avoid the exposure of direct
light, such as sunlight, or close-ranged torch light, and flashlight, during
the actual operation of tire tread check, brake disc check, and calibration.
3.1 Power Up
Press and hold the power button on the tool to switch it on. The system will
boot up and display the TBE200 Job Menu.
Figure 3-1 TBE200 Job Menu
① System Status Icons
② Application Buttons
③ Locator
3.1.1 System Status Icons
As the MaxiTPMS TBE200 runs on the Linux operating system, you may refer
to Linux documents for additional information.
To Next Page
Loading...
