10
TESTER CONFIGURATION
1. Store Information
2. For use with AMPNET. Set if email is desired
for test result.
Default Email: Email will be sent to the
account associated with AMPNET
Subscription.
Customer Email: Allows the customer to
provide a new email address to receive
results.
3. Temperature °F of °C.
4. Set to default to use previously used battery
rating unit. Clear to use previous rating value.
5. Set to default to use previously used rating
value. Clear to use default rating value.
6. Set to show a Near End of Life result. Clear to
show only Good and Bad battery result.
7. “Default CCA” Value.
8. Set will calculate cranking RPM starter result.
Clear skips calculation.
9. WiFi Setup.
10. Date and Time Setup.
11. Select print device.
1
2
3
4
5
6
7
8
9
10
11
To Next Page
Loading...
