15
STARTING TEST
BATTERY TEST cont.
The starting system test measures the amount of current needed to crank the engine,
cranking voltage, and cranking speed and provides the initial information to diagnose and/or
further test the starting system if necessary.
Symptomatic Check before Proceeding:
Check all cables and connections.
Check the battery for corrosion and dirty terminals.
Check starter/solenoid for visual defects.
Check the ignition switch and any magnetic switches
for loose or bad wiring, loose mounting, or connections
and sticking contacts.
Check for starter/solenoid noise. The type of noise or
the lack thereof can help in diagnosing the problem.
Does the solenoid click, but the starter does not turn?
Does the starter turn, but not engage the ywheel? Is
the starter sluggish?
The battery did not have
sufcient remaining capacity
to pass the loaded portion of
the test. The battery should be
replaced immediately
The battery did not have
a sufcient charge to do
an accurate test. Charge
the battery and then test
the battery.
To Next Page
Loading...
Need help?
General
