16
STARTING TEST cont.
Once the starting test
begins, The BVA-460
does some preliminary
measurements. This takes
about 7 seconds.
If the engine is running
the BVA-460 detects that
and displays this screen.
Once the engine is off this
screen will clear and the
test will continue.
When the BVA-460 is
ready it will prompt you to
start the engine.
If there is any connection issue, the
following screen will appear. Check
your connections to the battery and
make sure the posts are free of
corrosion. This screen will clear and
the test will continue once the
connection is correct.
When you are ready to run the
Starting test; for gasoline engines,
make sure the ignition key is in the
off position and all accessories are
off. Press the Start button. For diesel
engines, turn off all the accessories,
turn the ignition key to the run
position and wait for the glow plugs
to turn on then turn off. Press the
Start button.
Disconnect the Control Module from
the Load Module. Make sure the
engine is off. Connect the Large
clamps of the Load Module to the
battery. Place the load module
in a stable location in the engine
compartment so it will not fall when
the engine is started. Take the Control
Module with into the vehicle. From
the main menu press the Starting Test
button.
Next Page
To Next Page
Loading...
Need help?
General
