25
VOLTAGE DROP RESULTS
NOTE: If a total system voltage drop
greater than 500mV is
measured, the BVA-460 will
show a failed voltage drop test.
If the voltage drop is high the test will return
a bad result. The cable that is bad can be
determined by looking at the Pos and Neg
drop results. In this screen the positive cable
is the problem.
If the combined voltage drop of
the positive and negative circuit
is less than 500mV, the voltage
drop test passes. If the voltage
drop test fails you should start by
troubleshooting and repairing the
side of the circuit with the highest
voltage drop.
To Next Page
Loading...
