14
These screens show the results the BVA-460 will return after a battery test. The information shown is test number,
measured capacity, rated capacity, the state of health and the battery’s initial voltage. From here you can print the
results or save the results to AmpNet* if you have that service activated. All tests are saved internally in the BVA-460.
BATTERY TEST cont.
The battery passed the test and
can be returned to service.
The battery passed the test but
had a low initial voltage.
Charge the battery and then
return to service.
The battery passed the test,
but is near its end of life.
The battery is OK for mild
conditions, but may not
start a vehicle in hot or cold
conditions.
The battery did not have
sufcient remaining capacity
to pass the test. The battery
should be replaced
immediately.
Next Page
If the engine is running the
charging system will affect the
battery test. The BVA-460 will
detect that and prompt you to
shut off the engine before running
the battery test.
The BVA-460 will display the
progress of the battery test
To Next Page
Loading...
Need help?
General
