20
CHARGING TEST cont.
The BVA-460 will wait for the
vehicles system voltage to
stabilize. This can take up to 30
seconds.
Some vehicles have a fuel
saving mode that throttles back
the alternator if the battery is
charged and the loading is light.
When the BVA-460 detects this
it will ask you to turn on the
headlights which will throttle up
the alternator.
Again the BVA-460 will wait for
the vehicles system voltage to
stabilize. This can take up to 2
minutes.
Once the voltage is stable
the BVA-460 will test the
charging system.
Once the charging test is
complete. The BVA-460 will
display the test results. These
results include. Test Number.
Voltage regulation. Voltage
ripple. Output current. From
here you can print the results or
save the results to AmpNet if you
have that service activated. All
tests are saved internally in the
BVA-460.
To Next Page
Loading...
Need help?
General
