GDO-6 EasyRoller Installation Manual
2
Table of Contents
1. Installation Safety Warnings! 3
2. Kit Contents 4
3. Tools Required 4
4. Setup Requirements 5
5. Door Preparation 6
6. Fit the Weight Bar 6
7. Pinning the Door 7
8. Proping the Door 7
9. Mounting the Opener 8
9.1 Raising the Door: 8
9.2 Mounting the Opener: 8
10. Setting the Travel Limits 9
10.1 Initial Preparation: 9
10.2 Set the Limit Positions: 9
10.3 Resetting the Door Limit Positions 9
10.4 Setting the PET Mode position 9
10.5 Reset all Factory Defaults 9
11. Safety Testing 10
11.1 Test the Close Cycle 10
Testing the Open Cycle 10
11.2 Test the Manual Door Operation 10
11.3 Adjusting Safety Obstruction Force 10
11.4 To Increase Force Pressure 10
11.5 To Decrease Force Pressure 10
11.6 To Recall Factory Set Force 10
11.7 To Recalculate Force Margins 10
12. Accessories 11
12.1 Auxiliary Output 11
12.2 Keyswitch Connection 11
12.3 Remote Aerial 11
13. Auto-Close 11
13.1 Safety Beams 11
13.2 Auto Close Option 11
14. Coding a Transmitter 12
14.1 Storing the Transmitter Code 12
14.2 Coding a Button to Enable Vacation Mode 12
14.3 Coding to enable AUX Output 12
14.4 Setting to Operate PET (Pedestrian) Mode 12
14.5 Coding a Transmitter to the Courtesy Light 12
14.6 Easy Access Transmitter (EAT) Coding 13
14.7 Remotely Coding Transmitters 13
14.8 Erasing a Stored Transmitter Code 13
14.9 Erasing All Transmitter Codes 13
Installation Instructions
Home Owner Instructions
15. Home Owner Safety Warnings! 14
16. Opener Safety & Security 15
16.1 Your Door CAN NOT be used when: 15
16.2 Your Door CAN be used when: 15
16.3 To Disengage the Opener: 15
16.4 To Re-Engage the Opener: 15
17. Operating your Opener 15
18. User Operating Controls 16
19. Door Status Indicators 16
20. Specifications 17
21. Troubleshooting 18
22. After Installation Care 20
22.1 Service Checklist 20
22.2 Battery Replacement 21
22.3 Battery Disposal 21
22.4 Warranty 21
To Next Page
Loading...
