Automatic Technology GDO-6 v2 Slim-Drive EasyRoller

Need help?

Do you have a question about the Automatic Technology GDO-6 v2 Slim-Drive EasyRoller and is the answer not in the manual?

Summary

Important Safety Instructions

Features

ALPS Automatic Limits Positioning System

Intelligent Safety Obstruction System (ISS)

Reverses door if it hits an obstacle during closing or stops when opening.

Operating Controls

Before Installation

Safety Instructions for Installation

Critical warnings regarding incorrect installation causing severe injury or death.

Check Door Operation

Mounting the Opener

Fixing Drive Unit to Door

Detailed steps for attaching the drive assembly to the garage door shaft.

Setting Limits

Fix Door Curtain to Drum Wheel

Set Travel Limits via Control Panel

Procedure to set open and close limits using the opener's control panel buttons.

Setting Limits Positions

Step-by-step guide to manually adjust and store open/close limit positions.

Set Travel Limits via Remote Control

Procedure to set open and close limits using a remote transmitter.

Setting Safety Obstruction Force

Safety Obstruction Test

Procedures to test the door's auto-reverse function when encountering resistance.

Adjusting Safety Obstruction Force

How to increase or decrease the force margin sensitivity.

Recall Factory Set Force

Re-calculate Force Margin (ISS)

Recalculates the safety obstruction force parameters automatically.

Coding Transmitters

Storing Transmitter Codes

Procedure to store a transmitter's code into the opener's memory.

Setting Transmitter for Courtesy Light

Storing Transmitters from Remote Location

Deleting Programmed Codes

PE Beam and Auto Close

Fitting Safety Photo Electric Beam

Instructions for installing the optional photo electric beam sensor.

Setting Auto Close Time

Final Set Up

Reset All Factory Defaults

Re-initialising the Opener

Trouble Shooting