Automatic Technology SecuraLift GDO-9v3 - Button Functions

Owner Installation Instructions GDO-9v3 SecuraLift
®
31
Parameters
Button Functions
Buttons Function
OPERATE Opens/Stops/Closes the door
DOOR CODE Codes a transmitter button for operate, vocation,
auxiliary and pedestrian functions
LIGHT CODE Codes a transmitter button for light function
FORCE MARGIN SET & PLUS (+) Increases the obstruction force margin setting
FORCE MARGIN SET & MINUS (-) Decreases the obstruction force margin setting
FORCE MARGIN SET (then) SET Resets the factory default force margin settings
AUTO CLOSE TIME (then) PLUS (+) Increases the auto close delay time
AUTO CLOSE TIME (then) MINUS (-) Decreases the auto close delay time
AUTO CLOSE TIME (then) SET Resets the factory default auto close delay time
MINUS (-) for 6 secs. Clears the door limits set positions. Limits then
need to be reset
PLUS (+) for 6 secs. Enters pet (pedestrian) position mode
SET (then power on) & hold until all LEDs are off Deletes control parameters excluding transmitter
storage memory
DOOR CODE (then power on) & hold until all LEDs
are off
Deletes all transmitter storage memory
SET & DOOR CODE (the power on) and hold until all
LEDs are off
Deletes all control parameters and transmitter
storage memory.
SET Re-initialises the Opener to re-calculate force
margin