AutomationDirect D2-16ND3-2 - DL205 Combination Analog I;O Modules

DL205 Combination Analog I/O Modules
DL205 Installation and I/O Manual, 2nd Edition
3–72
Chapter 3: I/O Wiring and Specifications
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
F2-04AD2DA 4-Channel Analog Input / 2-Channel Analog Output Module
Number of Input Channels
4, single-ended (1 common)
Number of Output Channels
2, single-ended (1 common)
Ranges
4 to 20 mA current (current sinking)
Resolution
12 bit (1 in 4096)
Peak Withstanding Voltage
75 VDC, current outputs
Max. Continuous Overload
-40 to +40 mA, each current output
Input Impedance
250 , ±0.1%, 1/2 W,
25 ppm/ºC current input resistance
External Load Resistance
0 minimum, current outputs
Maximum Loop Supply
30 VDC
Recommended Fuse
0.032 A, series 217 fast-acting, current inputs
Maximum Load/Power
Supply
910 /24 V, current outputs
620 /18 V, 1200 /30 V
Active Low-pass Filter
-3 dB @ 20 Hz, 2 poles (-12 dB per octave)
Linearity Error (best fit)
±1 count (±0.025% of full scale) maximum
Output Settling Time
100 µs maximum (full scale change)
Accuracy vs. Temperature
±50 ppm/ºC full scale calibration change
(including maximum offset change)
Maximum Inaccuracy
±0.1% @ 77ºF (25ºC)
±0.3% @ 32 to 140ºF (0 to 60ºC)
Digital Input and Output
Points Required
16 (X) input points (12 binary data bits,
2 channel ID bits, 2 diagnostic bits)
16 (Y) output points (12 binary data bits,
2 channel enable bits)
PLC Update Rate
4 channels per scan maximum:
(D2-240, D2-250(-1) and D2-260 CPUs)
2 output channels per scan maximum:
(D2-240, D2-250(-1) and D2-260 CPUs)
1 input and 1 output channel per scan maximum:
(D2-230 CPU)
Base Power Required 5VDC
90 mA
External Power Supply
Requirement
18-26.4 VDC @ 80 mA
20 mA per loop
Operating Temperature
32º to 140ºF (0º to 60ºC)
Storage Temperature
-4º to 158ºF (-20º to 70ºC)
Relative Humidity
5 to 95% (non-condensing)
Environmental Air
No corrosive gases permitted
Shock & Vibration
MIL STD 810C 514.2
Noise Immunity
NEMA ICS3-304
Terminal Type (included)
Removable; D2-8IOCON
One count in the specification
table is equal to one least
significant bit of the analog
data value (1 in 4096).