Autonics LE4SA - Output Operation Mode

K-26
LE4S Series
※
Display 2
※
Display 1
[Fig.1]
Output operation mode
● Output operation mode
※
Output operation owchart
● LE4S/LE4SA output operation mode
NO
※
Display 1
※
Display 2 Operation mode LE4S LE4SA
1 OND ON Delay
2 OND
Ⅰ
ON Delay 1 -
3 OND
Ⅱ
ON Delay 2
4 FK Flicker
5 FK
Ⅰ
Flicker 1
6 INT Interval
7 INT
Ⅰ
Interval 1 -
8 ON OFF D ON-OFF Delay -
9 ON OFF D
Ⅰ
ON-OFF Delay 1 -
10 OFF D OFF Delay -
11 - STAR-Delay -
12 T Twin -
13 T
Ⅰ
Twin 1 -
1) In function setting mode, it enter into output operation mode as shown in the [Fig. 1].
2) Select proper output operation mode using and key.
(Refer to Output operation owchart)
3) Press
key to set output operation mode and move to next mode.
4) If pressing key for 3 sec. in any function setting mode, it will return to Run mode.
※
The shaded parameter(
) is factory default.
< LE4S >
< LE4SA >
OND ONd1 ONd2 FLK FLk1
INTINt1NFDNFd1OFD
ONd2 FLK FLk1
INTS-DTWN
OND
TWn1