Autonics LE4SA - Setting Time Change

K-29
(A)
Photo
electric
sensor
(B)
Fiber
optic
sensor
(C)
Door/Area
sensor
(D)
Proximity
sensor
(E)
Pressure
sensor
(F)
Rotary
encoder
(G)
Connector/
Socket
(H)
Temp.
controller
(I)
SSR/
Power
controller
(J)
Counter
(K)
Timer
(L)
Panel
meter
(M)
Tacho/
Speed/ Pulse
meter
(N)
Display
unit
(O)
Sensor
controller
(P)
Switching
mode power
supply
(Q)
Stepper
motor&
Driver&Controller
(R)
Graphic/
Logic
panel
(S)
Field
network
device
(T)
Software
(U)
Other
LCD Timer(Touch Type)
[Fig.1] [Fig.2] [Fig.3] [Fig.4] [Fig.5]
Setting time change
● Backlight ON/OFF setting
● Key Lock setting
● Output operation mode : OND, OND
Ⅰ
, OND
Ⅱ
, INT, INT
Ⅰ
, OFF D
(LE4SA does not have no OND
Ⅰ
, INT
Ⅰ
, OFF D.)
3) Press key to complete Backlight ON/OFF setting and move to the next mode.
4) If pressing key for 3 sec. in any function setting mode, it will return to Run mode.
Please set operation time according to following instruction as the setting is different depending on the output operation
mode.
1) Press
key in RUN mode, time set digits will ash.[Fig. 1]
2) Change setting time by using or key.[Fig. 2,3,4]
- key : Shift the setting digits.
- key : Shift the ashing position value. As press key once, it will increase by 1digit,
number will increase faster by press key for over 2sec.
3) When the setting is completed, it will be stored and return to RUN mode by pressing key.[Fig. 5]
Display Function
lOFF
Turns off the key Lock mode.
LOc1
key cannot be used.
LOc2
, key cannot be used.
LOc3
, , key cannot be used.
Turns off
the Lock mode.
Blank
key
cannot be used.
, key
cannot be used.
, , key
cannot be used.
key
key
[Fig.6]
※
Factory default
[Fig.7]
※
Factory default
key
key
key
key
1) In function setting mode, if it enter into Backlight ON/OFF setting mode, the characters will
be displayed as shown in the [Fig. 6].
2) Select Backlight
ON
or
OFF
using
, key.
1) In function setting mode, if it enter into Key Lock setting mode, the characters will be
displayed as shown in the [Fig. 7].
2) Select
lOFF
,
LOc1
,
LOc2
or
LOc3
using , key.
3) Press key to complete key lock setting and move to the next mode.
4) If pressing key for 3 sec. in any function setting mode, it will return to Run mode.
※
Factory default for LE4S is
lOFF
and Factory default for LE4SA is
LOc1
.
※
Key Lock function
key
key
key
key