Autonics LE4SA - Page 9

K-28
LE4S Series
[Fig.2]
[Fig.3]
[Fig.4]
[Fig.5]
※
Factory default
※
Factory default
※
Factory default
※
Factory default
● One-shot output time setting
● Time progress UP/DOWN setting
● The minimum input signal setting(LE4S only)
● Output contact setting(LE4SA only)
3) Press key to complete output contact setting and move to the next mode.
4) If pressing key for 3 sec. in any function setting, it will return to Run mode.
※
Except for Star-Delta, Twin and Twin 1 modes(
2C
is set automatically)
※
If pressing
key in Run mode, output contact setting value will be displayed.
(If no key is pressed over 3 sec., it will enter into function setting mode.)
3) Press
key to complete UP/DOWN setting and move to the next mode.
4) If pressing key for 3sec. in any function setting mode, it will return to Run mode.
RESET, START and INHIBIT.
1) In function setting mode, if it enter into input signal setting mode, the characters will be
displayed as shown in the [Fig. 4].
2) Select 1ms or 20 ms using
, keys.
When output operation mode ON Delay 2[
ONd2
],
1) In function setting mode, if it enter into One-shot output time setting mode as shown in
the [Fig. 2], the last digit will ash.
2) Set One-shot output time using
and key.(setting range: 0.01s to 99.99s)
3) Pressing key to complete one-shot output time setting and move to the next mode.
4) If pressing key for 3 sec. in any function setting mode, it will return to Run mode.
key
key
key
key
key
key
1) In function setting mode, if it advances to UP/DOWN setting mode, the characters will be
displayed as shown in the [Fig. 3].
2) Select
UP
(▲),
DN
(▼) using
, key.
3) Press key to complete input signal width and move to the next mode.
4) If Pressing key over 3 sec. in any function setting mode, it will return to Run mode.
1) In function setting mode, if it enter into output contact setting mode, the characters will be
displayed as shown in the [Fig. 5].
2)Select time limit 1c+instant limit 1c or time limit 2c using
, keys.
(Refer to LE4SA Connections on K-20 page for output contact connections)