Autonics SPC1 Series User Manual

I-50
SPC1 Series
Specications
Features
Single-Phase, Power Controller
● Various and simple input specication
• DC4-20mA, 1-5VDC, External 24VDC
• External adjuster (1kΩ)
• External contact (ON/OFF)
● Various function
• OUT ADJ (output limit) function
• SOFT START function (except for ON/OFF control method)
• OUT display function
• 50/60Hz automatic converting function
● Various control method by switch
• Phase control method
• Cycle control method (zero cross turn-on)
• ON/OFF control method (zero cross turn-on)
Ordering Information
Rated load current
Marking language
Item
SPC 35 E1 - -
35 35A
50 50A
E English
1 Single-phase
SPC Solid state power controller
Control phase
Model
SPC1-35-E SPC1-50-E
Power supply 220VAC
ᜠ
50/60
Hz
Allowable voltage range 90 to 110% of rated voltage
Operating frequency uctuation ±1Hz
Rated load current 35A (single-phase) 50A (single-phase)
Control power 220VAC
ᜠ
Control range Phase control: 0 to 98%, Cycle control: 0 to 100%
Applied load Resistance load (min. load: over 5% of rated current)
Cooling method Natural cooling
Control circuit Micom control type
Control input
• 1-5VDC
ᜡ
• DC4-20mA (250Ω) • ON/OFF (external relay contact or 24VDC
ᜡ
)
• External adjuster (1kΩ) • Output limit input (front OUT ADJ. adjuster)
Control
method
By selection
switch
• Phase control
※
1
• Cycle control (zero cross turn-on) - Period 0.5 sec, 2.0 sec, 10 sec
※
1
• ON/OFF control (zero cross turn-on)
Starting type SOFT START (0 to 50 sec variable)
Indicator Output indicator (OUT): red LED
Insulation resistance Over 100MΩ (at 500VDC megger)
Dielectric strength 2000VAC 50/60Hz for 1minute
Noise immunity ±2kV the square wave noise (pulse width: 1us) by the noise simulator
Vibration
Mechanical 0.75mm amplitude at frequency of 10 to 55Hz (for 1 min) in each X, Y, Z direction for 1 hour
Malfunction 0.5mm amplitude at frequency of 10 to 55Hz (for 1 min) in each X, Y, Z direction for 10 min
Shock
Mechanical 300m/s² (approx. 30G) in each X, Y, Z direction for 3 times
Malfunction 100m/s² (approx. 10G) in each X, Y, Z direction for 3 times
Environment
Ambient temp. 0 to 50
℃
, storage: -25 to 65
℃
Ambient humi. 35 to 85%RH, storage: 35 to 85%RH
Wire specication
AWG16 to 8
AWG8 to 6
Unit weight Approx. 1kg
※
1:
Refer to '
Operation and Function
'.
※
Environment resistance is rated at no freezing or condensation.
Please read “Safety considerations” in operation
manual before using.
SPC1 Series

Autonics SPC1 Series Specifications

General

Brand	Autonics
Model	SPC1 Series
Category	Controller
Language	English