Autonics TZ4ST-24S - Parameter Group 2 Settings; Display and Input Type Settings; Alarm Configuration; Tuning and Control Modes

J-150
TZN/TZ Series
● Parameter group 2
RUN mode
IN-T
EU-1
EU-2
AL-T
AtT
PIDT
O-FT
UNIT
H-SC
L-SC
DOT
FS-H
FS-L
RAMP
KCaH
AL-1
AL-2
AL-A
1300
`00
0
1300
`00
※
2
※
1
ON
ON
4800 9600
BPS
ㅁㅁ ADRS
LOC
01
OFF
OFF
2400
TVN2
PIdF
COOL
?F
TVN1
PIdS
HEAT
?C
+ 3 sec
3 sec
PV display
SV display
※
1: : ( )key-Switch elds, , key-Change values
※
2: Press the key after checking or changing the values in parameter
settings to save the setting value and move to the next parameter.
※
Hold the key for 3 sec anytime during parameter settings to save the setting
value and return to RUN mode.
※
The dotted line parameters may not appear depending on the model or
other parameter settings.
Input type
Event 1
Event 2
Alarm
option
Auto-tuning
mode
PID method
Heating/
Cooling
Temperature
unit
SV
high-limit
SV
low-limit
Decimal
point
Trans. output
high-limit
Trans. output
low-limit
Ramp
function
Com.
address
Com.
speed
Lock
Setting range: refer to ' Input Type and Range'.
OFF
Unlock
ON
Lock parameter 2
Setting range:
Setting range: refer to ' Input Type and Range'.
Setting range: refer to ' Alarm'.
※
Event 2 [
EU-2
] only appears in models that support Event 2 output.
Setting range: refer to ' Alarm'.
※
Does not appear when Event 1/2 [
EU-1
,
EU-2
] is set to
AL-0
,
LBA
,
SBA
.
Setting range:
0
,
)0
,
)00
,
)000
※
Only appears with analog input.
Setting range: refer to ' Input Type and Range'.
※
Only appears in models that support PV transmission.
※
Only appears in models
that support RS485
communication
Setting range: 1 to 99 (address)
※
Please set according to control application. Do not change the
settings during operation. It may result in re or accidents.