Autonics TZ4ST-24S - Configuration and Operation Basics; Configuring Input Type; Unit Display and Indicators; Key Functions and Operation

J-148
TZN/TZ Series
Unit Description
1. Present value (PV) display (red)
:
RUN mode: displays the current value (PV)
Setting mode: displays parameters
2. Set value (SV) display (green)
:
RUN mode: displays the set value (SV)
Setting mode: displays parameter setting values
3. SV2 operation indicator
: turns ON when SV2 is operating
4. Auto-tuning indicator
: turns ON when auto-tuning
5. Control output operation indicator
: turns ON when control output is ON. Does not operate when the control output
is current output.
6. Event output indicator
: turns ON when the according event output is ON.
※
The Event 2 output indicator does not operate in TZ4SP.
7. Mode key
: enter parameter group, return to RUN mode, switch parameters, save setting values
8. Auto-tuning key
: hold the key for 3 sec to start auto-tuning. Hold the key for 5 sec while auto-tuning to stop auto-tuning.
9. Setting keys
: enter SV change mode, switch elds, change value
( key in the dotted line is only available in TZ4M and TZ4L models)
10. Key adjustment order chart
SV Setting
8 9
1
3
2
5
6
4
7
8
7
1
2
5
6
9
10
4
3
※
When changing the previous SV of 0
℃
to 170
℃
,
( ) key: Switch elds
, key: Change values
The setting eld will blink.
key
key
①
RUN mode
②
SV setting mode
③
Complete SV setting
Conguring Input Type
Please congure the internal switches before supplying power. After supplying power, configure the input type [
IN-T
] in
parameter group 2 according to the input type.
Input type S/W 1 S/W 2
Thermocouple
1 1
mA V
RTD
Analog
Voltage
(0-10VDC,
1-5VDC)
2 2
mA V
Current
(DC4-20mA)
2 2
mA V
● Detaching the case
Press the front case then pull the
case to detach the case from the
body.
Congure the internal switches as
input type.