To Next PageTo Next Page
Need help?Do you have a question about the Autonics TZ4ST-24S and is the answer not in the manual?
General| Model | TZ4ST-24S |
|---|---|
| Storage Ambient Temperature | -20 to 60°C |
| Housing Material | Plastic |
| Number of Inputs | 1 |
| Number of Outputs | 2 |
| Input | Thermocouple, RTD, DC Current, DC Voltage |
| Output | Relay |
| Power Supply | 24V DC |
| Display Method | LED |
| Sampling Period | 0.5 sec |
| Operating Ambient Temperature | -10 to 50°C |
| Size | 48 x 48 mm |
| Output Rating | Relay output: 250 VAC~ 3 A 1a SSR drive output: 12 VDC ±1 VDC (NPN open collector), load current: max. 20 mA |
| Input Voltage | 24V DC |
| Response Time | 1 second |
| Control Method | ON/OFF control |
Details key functionalities like Dual PID auto-tuning, high display accuracy, and multi-input capabilities.
Lists supported input types including RTD, Thermocouple, and Analog signals with specifications.
Outlines control methods, PID parameters, alarm settings, and ramp function parameters.
Specifies the required panel cut-out sizes for different series models.
Provides detailed temperature ranges for Thermocouple, RTD, and Analog inputs in °C and °F.
Explains how to configure internal switches for input type selection before powering on.
Covers PID control parameters like proportional band, integral time, derivative time, and control period.
Explains input correction, manual reset for offset, ramp up/down times, and lock function settings.
Sets up event alarms (Event 1, Event 2) and alarm option modes (e.g., Standard, Latch).
Selects auto-tuning modes, PID control methods (P, PI, PD, PIDF), and heating/cooling modes.
Covers unit settings, limits, decimal points, transmission outputs, ramp function, communication, and lock settings.
Describes how to perform auto-tuning for PID parameter optimization and the available modes.
Explains various alarm operation modes like deviation, absolute value, and sensor break alarms.
Compares high-speed and low-speed PID response modes for optimal control.
Details RS485 communication interface, protocol, connection, and speed specifications.
Defines the structure and components of communication commands and responses.
Details the command format for reading process values and setting parameters.
Explains the command structure for writing setting values to the controller.
Lists important safety precautions and usage guidelines to prevent accidents and ensure proper operation.
