1. Power on the scale by pressing the ON/OFF key.
2. If the display stabilizes but doesn’t show zero, press the ZERO key to set new zero point.
3. Place the objects on the scale platform and read the weight on the indicator.
Note: Objects should be placed at the center of the platform. Corner or side loading heavy
objects may risk overloading an individual load cell and damage the scale.
4. To change the weight unit of measure, press the UNIT/COUNT key.
5. To send data to another device via the serial port, press the PRINT/HOLD key.
6. Power off the scale by pressing the ON/OFF key for 4 seconds.
1. Zero the scale as described above.
2. Place an empty container on the platform, press the TARE key. The display will return to zero,
eliminating the weight of the container. NET will be lit on the display.
3. Place the material or object to be weighed in the container. The net weight will be displayed.
4. To exit tare mode, remove all weight from the scale. The display will show a negative weight. Press
the TARE key to return the display to zero.
1. In normal weighing mode, press and hold the UNIT/COUNT key for 4 seconds to enter Count mode.
2. When the scale displays , place the samples on the scale and press the TARE key to confirm.
3. will flash, then scale displays , use the ↑ and → keys to input the quantity of samples,
press the TARE key to confirm. If any error occurs, the scale will display and will require
the quantity to be input again.
4. Put more parts on the scale for counting, the display will show the number of parts (pcs).
5. Press and hold the UNIT/COUNT key to return to normal weighing.
OPERATIONS & SETTINGS
7.
NORMAL WEIGHING MODE
YES NO NO
TARE FUNCTION
COUNTING
1. If the display does not show 0, and there is no object on the platform, press the ZERO key to zero the
reading.
• The zero function is unavailable when the displayed reading is out of the zero range and the indicator
will show the error message or meaning the scale is over or under the zero range.
ZERO FUNCTION
1. Press and hold the PRINT/HOLD key for 4 seconds while scale is under load.
2. HOLD will be displayed and the weight will remain saved after unloading the scale.
3. To deactivate the Hold function, press and hold the PRINT/HOLD key for 4 seconds.
HOLD FUNCTION
The Hold function is used if you would like to hold the results on the display after the weight/load
has been removed from the scale.
To Next Page
Loading...
