AVANT 220 - Component Checks; Tyre Pressure Check; Bolt and Fitting Tightness; Battery Check

Avant 220/225
63
2.
Levelling bar, both ends
2
3.
Tilt cylinder, both ends
2
4.
Pivot pin on attachment coupling
plate/boom
3
5.
Pivot pin on loader boom
1
6.
Steering cylinder, both ends
2
7.
Articulation joint
2
3. Tyre pressure check
Check tyre pressure when heavy attachments and
extra counterweights are not attached. Correct tyre
pressure depends on intended load. Refer to
Chapter Technical Specifications.
4. Check and tightening of bolts, nuts
and fittings
Check tightness of bolts, nuts and hydraulic fittings
regularly. However, do not overtighten; tighten
hydraulic fittings only if necessary.
Wheel nuts should be tightened 150 Nm.
Check the tightness of the pivot pin locking screws, if
loose tighten and use thread locker.
Tighten wheel nuts after first 5
operating hours. Check tightness of
wheel nuts regularly.
5. Battery check
WARNING
Before handling the battery, see
safety instructions about handling
the battery on page 13.
The battery is located under a cover plate, under the
left side of floor of the loader.