Avant 220/225
68
4. Change engine oil filter
Engine oil filter is located on the right hand side of
the machine, and can be seen from the engine
compartment.
5. Engine oil cooler
Fitted on the right side of the engine, there is an
engine oil cooler. The cooler must be cleaned
regularly, and if operating in dusty conditions, check
the cleanliness of the cooler daily.
To clean the cooler:
1. Clean fins with a brush or compressed air.
2. Remove two screws securing oil cooler (upper
screw shown), and tilt to clean back side.
3. Reinstall oil cooler.
6. Fuel filters
Fuel filters - 220 225
The fuel lines run through a filter by the engine.
Care must be taken when replacing the fuel filter.
Make sure to keep all parts clean during service.
Service only cold engine. In demanding operating
environment the fuel filter must be changed more
frequently than the recommended maintenance
interval.
Fuel filter (225LPG)
There are two filters in the LPG system
30 µm button filter in pressure regulator
10 µm LPG EFI filter
See engine owners manual for replacement
instructions.
7. Check fuel lines
220 / 225:
Check all fuel lines and hose clamps for signs of
wear or damage. In case a fuel hose needs to be
replaced, replace all hoses and clamps at the same
time.
Check fuel tank externally. Check for abrasions,
signs of deformation, or other wear that makes it
necessary to replace the fuel tank with a new one.
Check also the fuel cap.
Use only original type of fuel cap. Lockable cap is
also available.
225LPG
Check the fuel hose connected to LPG cylinder every
time when changing the LPG cylinder. Use a high
quality LPG hose that fulfils the same standards as
the original hose and is intended to be used with
LPG at working pressures.
To Next Page
Loading...
