28
500 Series
Battery disconnect switch
The loader is equipped with a
battery disconnect switch. The
switch is located in the rear of
the machine, on the right side
(see picture). Always switch off
main current when you leave the
loader unattended, and before
you do any maintenance or inspections.Switching the
battery disconnect switch to position OFF (horizontal
position of the switch key) will isolate the battery from the
electric system of loader, and will prevent hazards related
to damaged electric wires, short-circuit, and overheat of
electric components.
Risk of re - Always switch off
main current when the loader
is not used. Turn the battery
disconnect switch to position
OFF whenever leaving the loader
unattended or before servicing
the machine. If left on, there is
a risk of sparks and short-circuit
during maintenance and if any
electric insulator is faulty.
Controls in the footwell
Following picture shows the controls located in the footwell
1. Drive pedal, left: drive backward
2. Drive pedal, right: drive forward
See correct operation of the drive pedals on page 37.
Installing of service support
The red service support of the
boom lift cylinder is located at
the tip of the boom, behind the
attachment coupling plate.
Make sure that the boom
stays up during maintenance
operations by attaching the
service support on the lift
cylinder piston rod. Secure the
service support by locking it
on the piston rod with the long
screw that is on the support.
Risk of crushing - Always
secure the boom service
support on the boom lift
cylinder before going under
the boom or any attachment.
Always secure the loader
boom with the provided service
support, before going under
the loader boom. Remove any
load and attachments from
the loader before service or
maintenance.
Operating instructions
To Next Page
Loading...
