32 33
SAFETYINSTALLATIONOPERATION SUBFINE TUNING
MISC
WARRANTY
OPERATION
SAFETYINSTALLATIONOPERATION SUBFINE TUNING
MISC
WARRANTY
OPERATION
FINE TUNING
LISTENING HEIGHT
Depending on the listening distance and seat height, it may be im‐
portant to tilt the speaker systems forward or backward.
If necessary, tilt the speaker slightly forward or backward by turning
the handle of the 4 x spike assemblies until the system is opti‐
mally aligned.
RUN–IN TIME
Brand new horns and subwoofers usually need at least 40 hours of
running–in. During this period sound quality will improve
continuously. Please leave the subwoofers ON during this run–in
period.
After this run–in, the sound might have been altered and it might
be necessary to slightly re–tune the system set–up (positioning and
subwoofer-settings).
WARM–UP TIME FOR ITRON
The ITRON electronics uses pure CLASS–A circuits with Zero–
Feedback. To reach its full sonic potential the components need to
be fully warmed–up. A suff icient warm up time (> 15 minutes) prior
to serious listening is recommended.
2
1
1
2
1
3
MISCELLANEOUS
12V DC TRIGGER
The 12V DC TRIGGER sockets of the ITRON & SPACEHORN electron‐
ics features an “IN”–socket and an “OUT”–socket . This way it
is easily possible to remotely switch ON/OFF additional devices (ad‐
ditional SPACEHORNS etc.) by simply daisy–chain the 12V trigger
signal.
Wiring can be made with mono or stereo jack cables.
E–FUSE
All Avantgarde electronics are equipped with a state–of–the–art
electronic protection circuit. This E–FUSE continuously monitors
the unit and in the event of a fault immediately interrupts the flow
of current with unrivaled precision & speed and thus protects the
device f rom damage.
When the E–FUSE has tripped, the current flow will be interrupted
and the device stops operating. The red engaged fuse LED will
illuminate. Press the E–FUSE RESET button to reset. If the E–
FUSE keeps tripping, a permanent malfunction has occurred.
Disconnect the device from the mains and get it serviced by your
dealer.
All Avantgarde electronics are equipped with a mains ON–OFF
power switch that includes an external fuse holder . To avoid any
kind of sound degradation caused by conventional fuses, the
accessoried include glod-plated copper bolts that can replace the
glass fuses used in the factory and thus eliminating any sound
degradation at this point. NOTE: The certif ied f inal tests during final
assembly are performed with glass fuses in place, therefore these
are also installed as standard in the delivery status.
For whatever reason this copper bolt may at any time be replaced
by a conventional 2.5 amp slow blow glass fuse.
FUTURE UPGRADES (optional future upgrade only).
Your system has already been equipped with a wifi antenna port to
support future upgrades. This includes remote control signals (from
apps etc.) and receiving OTA (over the air) update files for the
firmware of the built–in controller chipset.
MISC
FINE TUNING
�
To Next Page
Loading...
