Chapter 3: Installation
Installation checklist
Use the following checklist to complete the installation of the server.
No. Task Description Notes
1 Discharge electrostatic energy. See Electrostatic discharge on
page 17.
2 Inspect package contents. See Package contents on
page 18.
3 Install the server using the rail kit. See Installing the server on
page 19.
4 Attach cables. See Attaching cables on
page 23.
5 Connect power. See Connecting power on
page 24.
The following items are application-specific. Refer to the application-specific documentation for
additional information.
• Initial configuration and IP address assignment.
• Ethernet port cabling.
• Shutdown procedures.
Electrostatic discharge
Electrostatic discharge (ESD) is a discharge of stored static electricity that can damage equipment
and impair electrical circuitry. Electrostatic voltages can result from friction including, pulling
cabling through conduits, walking across carpeted areas, and building static charge in clothing.
When you improperly handle electronic components, ESD damage occurs and can result in
complete or intermittent failures. While networking equipment is commonly designed and tested to
withstand common mode ESD events, voltage can sometimes discharge to some connector pins,
which can potentially damage the networking equipment.
December 2018 Installing the Avaya Converged Platform 120 Series 17
Comments on this document? infodev@avaya.com
To Next Page
Loading...
