Avaya 4500 - Setting IPFIX Timers

Avaya Inc. – External Distribution
9
avaya.com
2.2 Setting IPFIX timers
CLI (same output as shown via PPCLI below):
 ERS 8600
o ERS-8600(config)# ip ipfix slot <slot #> ?
 ERS 8300
o ERS-8300(config)# ip ipfix ?
PPCLI:
 ERS 8600
o ERS-8600# config ip ipfix slot <slot #> ?
Sub-Context: collector
Current Context:
active-timeout <value in mins>
aging-interval <value in secs>
export-interval <value in secs>
exporter-state <enable|disable>
info
template-refresh [refresh-interval <value>] [packets <value>]
 ERS 8300
o ERS-8310# config ip ipfix ?
Sub-Context: collector port
Current Context:
active-timeout <value in mins>
aging-interval <value in secs>
export-interval <value in secs>
exporter-state <enable|disable>
info
state <enable|disable>
template-refresh [refresh-interval <value>] [packets <value>]
where:
Parameter
Description
active-timeout
Specifies the active timeout in minutes. Range is from 1 to 60 minutes.
aging-interval
Specifies the interval, in minutes, when to flush out the old flows after
they have stopped. Range is from 10 to 3600 seconds. Default setting
is 30 minutes.
export-interval
Specifies the interval, in seconds, between exports. Range is from 10
to 3600 seconds. Default value is 50 seconds.
exporter-state
Indicates whether IPFIX is enabled or disabled on the switch.
info
Displays configuration.