Avaya 4500 - IPFIX Collector Setup

Avaya Inc. – External Distribution
10
avaya.com
template-refresh
Specifies the interval, in seconds, between refreshes and the interval,
in number of packets, between refreshes. Range for interval is 300 to
3600 seconds. Range for packets is 10,000 to 100,000.
2.3 IPFIX Collector Configuration
The following command is used to configure an IPFIX collector.
CLI:
 ERS 8300
o ERS-8300(config)# ip ipfix collector <ipaddr> ?
 ERS 8600
o ERS-8600(config)# ip ipfix collector <slot#> <ipaddr> ?
dest-port Destination port
enable State of the collector
exporter-ip Ip address of the exported traffic
protocol Type of the protocol
protocol-version Ipfix protocol version
PPCLI:
 ERS 8300:
o ERS-8300# config ip ipfix collector ?
 ERS 8600
o ERS-8600# config ip ipfix slot <slot #> collector ?
Sub-Context:
Current Context:
add <ipaddr> [protocol <value>] [dest-port <value>] [exporter-
ip <value>] [protocol-version <value>] [enable <value>]
info
remove <ipaddr>
where:
Parameter
Description
slot#
Indicates the slot for the collector.
Note: If you do not specify a slot, the command applies to all
slots.
<ipaddr>
Specifies the IP address of the collector you are adding.
protocol
Specifies the protocol to use. UDP is the default.
dest-port
Specifies the destination port.