Avaya 4500 - IPFIX Configuration on ERS 8600 & ERS 8300; Enabling IPFIX Globally and Per Port

Avaya Inc. – External Distribution
7
avaya.com
2. IPFIX Configuration on ERS 8600 & ERS
8300:
2.1 Enabling IPFIX globally and on a port level
To enable or disable IPFIX globally, enter the following command.
CLI:
 ERS-Switch(config)# ip ipfix enable
 ERS-Switch(config)# no ip ipfix enable
PPCLI:
 ERS-Switch# config ip ipfix state <enable|disable>
To enable IPFIX on a port level, enter the following command:
CLI:
 ERS-Switch(config)# interface < FastEthernet| GigabitEthernet> <slot/port>
 ERS-Switch(config-if)# ip ipfix enable
PPCLI:
 ERS-Switch# config ip ipfix port <slot|port> all-traffic enable
Additional port parameters specific to ERS 8600 and ERS 8300
CLI:
 ERS8600(config-if)# ip ipfix ?
enable To enable ipfix
hash-key To set hash-key
hash-polynomial-coeffs To set hash-polynomial-coeff
hash-polynomial-seed To set hash-polynomial-seed
port Ipfix configuation on a specified port
sampling-rate To set sampling rate
 ERS8300(config-if)# ip ipfix ?
enable To enable ipfix
port Ipfix configuation on a specified port
PPCLI:
 ERS-8600# config ip ipfix port <slot|port> ?
Sub-Context:
Current Context:
all-traffic <enable|disable>
flush [export-and-flush]
hash-key <id>
hash-polynomial [coeffs <value>] [seed <value>]
info
sampling-rate <1-100000>