Avaya 4500 - IPFIX Configuration Examples for the ERS 8600; IPFIX Configuration Example ERS 8600

Avaya Inc. – External Distribution
12
avaya.com
3. IPFIX Configuration Examples for the
ERS 8600
3.1 IPFIX Configuration Example for the ERS 8600:
For this configuration example, we will configure the following:
 Enable IPFIX collecting on port 7/26
 Configure the IPFIX active-time to 30 seconds. This will allow viewing the IPFIX flows
on port 7/26 for up to 30 seconds.
 Add an IPFIX collector which has an IP address of 172.30.30.20. We will leave the
default setting of protocol type UDP with a dst-port of 9995.
3.1.1 Configuration
To accomplish the above, please enter the following commands:
ERS 8600: Step 1 – Enable IPFIX globally
CLI:
ERS-8600(config)# ip ipfix enable
PPCLI:
ERS-8600# config ip ipfix state enable
ERS 8600: Step 2 – Enable IPFIX on port 7/26
CLI:
ERS-8600(config)# interface gigabitEthernet 7/26
ERS-8600(config-if)#ip ipfix enable
ERS-8600(config-if)# exit
PPCLI:
ERS-8600# config ip ipfix port 7/26 all-traffic enable