Avaya 4601 - Page 32

4600 Series IP Telephone Installation
32 4600 Series IP Telephone Installation Guide
10. The telephone contacts the Avaya Media Server and attempts to log in.
All IP telephones except the 4601 display the following prompt for an extension:
The 4601 IP Telephone indicates the server is waiting for an extension entry by flashing the
Message Waiting Indicators 500 milliseconds on, 500 milliseconds off. The Message
Waiting indicators are located at the top of the telephone and the Message button LED on
the left middle of the faceplate.
11. Enter a new extension, ending with the # button. All telephones except the 4601 display
each digit entered, while the 4601 provides LED and button-click feedback. To register the
telephone without the extension or password (unnamed), press only the # button or make
no entry and wait 60 seconds.
Note:
Note: Unnamed registration is the capability to register a telephone with the call server
without entry of an extension or password. The UNNAMEDSTAT parameter must
be set to enable unnamed registration. Telephones registered unnamed have
limited functionality. For more information, see Unnamed Registration
on
page 36.
All IP telephones except the 4601 display the following prompt for a password:
12. Enter the password, ending with the # button. The 4601 provides LED and button-click
feedback for each digit upon entry. To register the telephone without the extension or
password (unnamed), press only the # button or make no entry and wait 60 seconds.
Except for the 4601, the extension is visible as you enter it but the password displays as
asterisks. The 4601 just provides LED and button-click feedback for password entry.
13. If entered, the system determines whether the extension is in use and if the password is
valid.
14. Successful completion of this process produces the dial tone.
The IP telephone was installed successfully.
Extension=nnnnnn
#=OK NEW=_
Password=_
#=OK