Group Identifier
Issue 3 April 2006 55
Group Identifier
Use the following procedure to set or change the Group Identifier.
Note:
Note: Perform this procedure only if the LAN Administrator instructs you to do so.
The 4601 IP Telephone does not support the Group Identifier.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 4 7 6 8 7 (Mute G R O U P)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons. The 4630/4630SW IP Telephones and the 4690 IP Conference
Telephone do not have a dedicated Hold button. For all other 4600 Series IP
Telephones, pressing the Hold button instead of the Mute button also works.
The following text displays left-justified at the top of the display:
where ddd is the Group value.
2. Enter a valid Group value (0-999).
If a value different from the current Group value is entered, the following text displays
left-justified at the top of the display:
3. Press the * button to terminate the procedure, or the # button to save the new value.
If you press the # button, the following text displays:
The new value is saved and the user interface is restored to its previous state.
Group=ddd
New=_
Save new
value?
*=no #=yes
New value
being saved
To Next Page
Loading...
