Local Administrative Options
64 4600 Series IP Telephone Installation Guide
indicate no entry is allowed while the system values are being reset. All other phones
display the following text left-justified at the top of the display while the system values are
reset to defaults:
Once the system values are reset, the following prompt displays on all IP telephones,
except the 4601:
3. Press the * key to terminate the procedure without restarting the telephone.
Press the # key to restart the telephone.
The remainder of the procedure depends on the status of the boot and application files.
See Appendix A: Restart Scenarios
.
Signaling Protocol Identifier
Use the following procedure to set or change the Signaling Protocol Identifier. A valid SIG
Protocol Identifier is either 0 (default), 1 (H.323), or 2 (SIP).
Note:
Note: Perform this procedure only if the LAN Administrator instructs you to do so.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 7 4 4 (Mute S I G)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons. The 4630/4630SW IP Telephones and the 4690 IP Conference
Telephone do not have a dedicated Hold button. For all other 4600 Series IP
Telephones, pressing the Hold button instead of the Mute button also works.
Resetting
values.
Restart
phone?
*=no #=yes
To Next Page
Loading...
