Avaya 4601 - Page 35

Converting Software on Avaya 4600 Series IP Telephones
Issue 3 April 2006 35
Table 1: H.323 to SIP and SIP to H.323 Conversion Chart
Environment
To convert this
type of telephone
To this type
of telephone
Then:
H.323-centric H.323 in use SIP Perform the Mute SIG procedure to change
the SIG parameter value from “default” to
“2" (SIP).” For information, see Signaling
Protocol Identifier on page 64.
Press * to save the SIG parameter change.
Restart the telephone as covered in Restart
the Telephone on page 63.
H.323-centric H.323 factory set SIP Connect the telephone to a power source
and to the network.
As soon as you see the DHCP prompt, press
* to enter manual programming mode. Press
# multiple times to accept the existing values
until the telephone displays “Enter
command.”.
Perform the Mute SIG procedure and
change the value from “default” to “2" (SIP).
Press * to save the SIG parameter change.
Restart the telephone as covered in Restart
the Telephone on page 63.
H.323-centric SIP H.323 Perform the Mute SIG procedure to change
the SIG parameter value from “2" (SIP) to
“default” (H323). For information, see
Signaling Protocol Identifier
on page 64.
Press * to save the SIG parameter change.
Restart the telephone as covered in Restart
the Telephone on page 63.
Save the change & restart telephone.
SIP-centric SIP H.323 Perform the Mute SIG procedure to change
the SIG parameter value from “default” to
“1" (H323). For information, see Signaling
Protocol Identifier on page 64.
Press * to save the SIG parameter change.
Restart the telephone as covered in Restart
the Telephone on page 63.
1 of 2