Chapter 3: Safety and equipment care
information
This chapter contains important safety and regulatory information. Read this section before you
install Small Form Factor Pluggable (SFP) or Small Form Factor Pluggable Plus (SFP+)
transceivers.
Fiber optic equipment care
Use the information in this section to properly maintain and care for fiber optic equipment.
Transceivers are static sensitive.
Dust contamination can reduce the performance of optical parts in transceivers. When you store a
transceiver, or after you disconnect it from a fiber optic cable, always keep a dust cover over the
optical bore.
Dispose of this product according to all national laws and regulations.
To prevent equipment damage, observe the following electrostatic discharge (ESD) precautions
when you handle or install the components:
• Ground yourself and the equipment to an earth or building ground. Use a grounded workbench
mat (or foam that dissipates static charge) and a grounding wrist strap. The wrist strap must
touch the skin and you must ground it through a one megaohm resistor.
• Do not touch anyone who is not grounded
• Leave all components in their ESD-safe packaging until installation, and use only a static-
shielding bag for all storage, transport, and handling.
Clear the area of synthetic materials such as polyester, plastic, vinyl, or styrofoam because
these materials carry static electricity that damages the equipment.
Fiber optic cable care
Although reinforcing material and plastic insulation protects the glass fiber in fiber optic cable, it is
subject to damage.
April 2016 Installing Transceivers and Optical Components on Avaya ERS 4900 and 5900
Series 13
Comments on this document? infodev@avaya.com
To Next Page
Loading...
