Model Description Part number Minimum software version
ERS 5900 ERS 4900
10GBASE-ZR/ZW
SFP+
70 km, 1550 nm
SMF
AA1403016-E6 7.0 7.1
10GBASE-ER
CWDM DDI SFP+
40 km, 1471 to
1611 nm
AA1403153-E6 to
AA1403160-E6
7.1 7.1
10GBASE-ZR
CWDM DDI SFP+
70 km, 1471 to
1611 nm
AA1403161-E6 to
AA1403168-E6
7.1 7.1
10GBASE-BX10
SFP+
10 km AA1403169-E6 and
AA1403170-E6
7.1 7.1
Installing an SFP+
Install an SFP+ transceiver to provide a 10-gigabit Ethernet interface between the device and other
network devices.
Before you begin
Important:
Do not install an SFP+ transceiver in an SFP slot. The two transceivers look the same but
function differently. Ensure the slot is an SFP+ slot.
• Verify that the SFP+ transceiver is the correct model for your network configuration.
• Before you install the optical connector, ensure it is clean.
Danger:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into
an optical fiber or connector port. Always assume that fiber optic cables connect to a light
source.
Electrostatic alert:
ESD can damage electronic circuits. Do not touch electronic hardware unless you wear a
grounding wrist strap or other static-dissipating device.
Warning:
Risk of equipment damage
Only trained personnel can install this product.
About this task
Installing an SFP+ transceiver takes approximately 3 minutes.
Procedure
1. Remove the SFP+ transceiver from its protective packaging.
SFP+
April 2016 Installing Transceivers and Optical Components on Avaya ERS 4900 and 5900
Series 42
Comments on this document? infodev@avaya.com
To Next Page
Loading...
