Avaya 4900 Series - SFP labels; General SFP specifications

The specifications in this section meet or exceed those specified in the applicable IEEE standards,
where they exist.
In these specifications, unless otherwise noted, receiver sensitivity is the minimum average input
optical power for which the receiver is guaranteed to meet the bit error rate (BER) of 10
-12
.
SFP labels
The Avaya label on a typical SFP transceiver contains an Avaya serial number, a bar code, a
manufacturer code, an interface type, and a part number.
Figure 1: SFP label
General SFP specifications
The following table describes general SFP specifications.
Table 2: General SFP specifications
Parameter Description
Dimensions (H x W x D) 8.5 x 13.4 x 56.4 millimeters (0.33 x 0.53 x 2.22
inches), unless otherwise stated.
Operating temperature –5 to 85 ºC for RoHS -E6 models
Storage temperature –40 to 85 ºC
Maximum supply current 300 mA, unless otherwise stated
Maximum power consumption 1.0 W, unless otherwise stated
SFP specifications
April 2016 Installing Transceivers and Optical Components on Avaya ERS 4900 and 5900
Series 27
Comments on this document? infodev@avaya.com