Model Description Part number Minimum software version
ERS 5900 ERS 4900
about EOS
transceivers, and
recommended
replacements for
your product, see
Locating end of
sale notices on
page 11.
Installing an SFP
Install an SFP to provide an interface between the device and the network cable.
Before you begin
• Verify that the SFP is the correct model for your network configuration.
• Before you install the optical connector, ensure it is clean.
Danger:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into
an optical fiber or connector port. Always assume that fiber optic cables connect to a light
source.
Electrostatic alert:
ESD can damage electronic circuits. Do not touch electronic hardware unless you wear a
grounding wrist strap or other static-dissipating device.
Warning:
Risk of equipment damage
Only trained personnel can install this product.
About this task
Installing an SFP takes approximately 3 minutes.
Procedure
1. Remove the SFP from its protective packaging.
2. Grasp the SFP transceiver between your thumb and forefinger.
3. Insert the device into the port on the module.
Depending on the module type, you must insert some SFP transceivers into the port with the
bail facing up and some SFP transceivers with the bail facing down.
SFP
April 2016 Installing Transceivers and Optical Components on Avaya ERS 4900 and 5900
Series 24
Comments on this document? infodev@avaya.com
To Next Page
Loading...
