Avaya 4900 Series - Supported SFP transceivers

Supported SFP transceivers
The following section provides specifications for the supported SFP transceivers.
1000BASE-T SFP specifications
The 1000BASE-T SFP provides gigabit Ethernet connectivity using a single eight-pin RJ-45
connector.
The 1000BASE-T SFP operates at 1 gigabits per second (Gbps). Only the ERS 5632 can operate at
tri-speeds, and program the 1000BASE-T SFP to operate at 1 Gbps, 100 megabits per second
(Mbps) and 10 Mbps speeds.
The part number for this model is AA1419043-E6.
The maximum current requirement of the SFP is 375 milliamperes (mA) at 5 volts (V).
The following table describes the 1000BASE-T SFP specifications.
Table 3: IEEE 802.3z 1000BASE-T SFP specifications
Parameter Specifications
Standards IEEE 802.3z, IEEE 802.3ab
Connectors RJ-45
Cabling CAT5E or better UTP
Distance Up to 100 m
1000BASE-SX (LC) SFP specifications
The 1000BASE-SX SFP transceiver provides 1000BASE-SX gigabit Ethernet connectivity at 850 nm
using multimode optical fiber. This SFP supports only full-duplex operation. The part number is
AA1419013-E5.
The following table describes standards, connectors, cabling, and distance for the 1000BASE-SX
SFP transceivers.
Table 4: IEEE 802.3z 1000BASE-SX (LC) SFP specifications
Parameter Specifications
Connectors Duplex LC
Cabling • 62.5 µm MMF optic cable
• 50 µm MMF optic cable
Distance • up to 275 m using 62.5 µm MMF optic cable
• up to 550 m using 50 µm MMF optic cable
Wavelength 850 nanometers (nm)
Table continues…
SFP
April 2016 Installing Transceivers and Optical Components on Avaya ERS 4900 and 5900
Series 28
Comments on this document? infodev@avaya.com