Important:
Pressing star (*) at this time invokes the Craft Access entry procedure to allow manual
settings.
9. When connected, the phone looks for an upgrade script file.
10. The HTTP server sends and identifies an upgrade script.
The phone might send the GET message several times. Each time the GET message is
sent, all IP phones display the following message: HTTP: n uri
For HTTP, n is the number of HTTP requests made by the phone and uri is the URI for the
current HTTP request.
Note:
The SIG parameter value determines the signaling protocol whether H.323 or SIP, and
is used to determine the proper upgrade file that is downloaded. If you set the SIG
parameter manually using the local administrative Craft SIG procedure, that value
takes precedence over a SIG setting in a configuration file. A change in the SIG value
might require a reset to the phone so that a new or different upgrade file can be
downloaded to the phone.
11. While the upgrade script file is being downloaded, all IP phones display the following
message: HTTP: n sc etag
where n is the number of the IP address obtained from the HTTP server, sc is the status
code of the HTTP response, and etag is the value of the ETag header.
12. When the phone establishes the validity of the application file received, the phone displays
the following message: File Obtained; please wait...... s secs
where s is the number of seconds that elapse while non-volatile memory is erased.
13. While the application file is saved in flash memory, all IP phones display the following
message: Saving to flash 1% 1 secs
where the percentage of the file and the number of elapsed seconds increase as the
application file is stored in flash memory.
14. The phone contacts the Avaya Communication Manager and displays a login screen that
displays the following:
Login, Enter Extension, or Enter Extension and press Enter or OK.
Steps to be performed by user after phone displays login and extension prompts:
1. Enter a new extension and press OK. To register the phone without the extension or
password (unnamed), press only OK or make no entry and wait 60 seconds.
Note:
Unnamed registration is registering a phone with the call server without entry of an
extension or password. You must set the UNNAMEDSTAT parameter to enable
unnamed registration. phones that are registered unnamed have limited functionality.
Installing the Deskphone
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 32
Comments on this document? infodev@avaya.com
To Next Page
Loading...
