SWITCHING CONNECTIONS DURING CALLS
Adding a new connection during a call
You can add another connection or switch between connection during a call.
Press the button during the call.
An indicator appears on the display screen in front of the selected connection.
Use the arrow buttons to mark the connection you want to activate and confirm your
choice by pressing OK.
If you selected USB or MOBILE, this connection will open. You then connect the call via the
computer or mobile phone.
If you selected DECT, you will hear a dialling tone. You then dial the number on the Avaya B169
or use the Phonebook.
Press the key again to close the connectivity menu.
Putting a connection on hold during a call
Press the button during the call.
Use the arrow buttons to mark the connection you want to put on hold and press
the button.
The indicator in front of the selected connection starts to flash.
Repeat the above to reconnect the connection.
Press the key again to close the connectivity menu.
Disconnecting a connection during a call
Press the button during the call.
Use the arrow buttons to mark the connection you want to disconnect and confirm
your choice by pressing .
The indicator in front of the selected connection goes out and the connection is disconnected.
The other calls can continue.
Press the key again to close the connectivity menu.
DURING A CALL
To Next Page
Loading...
