Interface Control
Issue 1 June 2010 109
● Status is errors when NVLOGSTAT = 4
● Status is warnings when NVLOGSTAT = 5
● Status is notices when NVLOGSTAT = 6
● Status is information when NVLOGSTAT = 7
● Status is debug when NVLOGSTAT = 8
3. To change the logging status, press *.
Depending on the current value, the next sequential valid NVLOGSTAT value is selected
and displayed as the status. For example, if the current value is alerts (2), pressing *
changes the value to 3 (critical). If the current value is debug (8), pressing * changes the
value to 0 (disabled).
If a value different from the current NVLOGSTAT value is entered, the following text displays
left-justified at the top of the display:
4. Press the * button to terminate the procedure, or the # button to save the new value. If you
press the # button, the telephone displays the following text:
The telephone saves the new value.
Logoff
Use the following procedure to log off a telephone.
!
CAUTION:
CAUTION: Once a telephone is logged off, a password and extension might be needed to
log back on.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 5 6 4 6 3 3 # (Mute L O G O F F #)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons.
Save new value?
*=no #=yes
New value being saved
To Next Page
Loading...
