EasyManua.ls Logo

Avaya one-X 1603SW - DHCP Configuration Details

Avaya one-X 1603SW
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Server Administration
50 Avaya 1603SW-I SIP Deskphones Administrator Guide
DHCP Generic Setup
This section is limited to describing a generic administration that works with the 1603SW-I SIP
IP Deskphones. Three DHCP software alternatives are common to Windows operating
systems:
Windows NT
®
4.0 DHCP Server
Windows 2000
®
DHCP Server
Windows 2003
®
DHCP Server
Any other DHCP application might work. It is the responsibility of the customer to install and
configure the DHCP server correctly.
DHCP server setup involves:
1. Installing the DHCP server software according to vendor instructions.
2. Configuring the DHCP server with:
IP Addresses available for the 1603SW-I SIP IP Deskphones.
The following DHCP options:
- Option 1 - Subnet mask.
As described in Table 3
, item 3.
- Option 3 - Gateway (router) IP Address(es).
As described in Table 3
, item 1. If using more than one address, the total list can
contain up to 127 total ASCII characters. You must separate IP Addresses with
commas with no intervening spaces.
- Option 6 - DNS server(s) address list.
If using more than one address, the total list can contain up to 255 total ASCII
characters. You must separate IP Addresses with commas with no intervening spaces.
At least one address in Option 6 must be a valid, non zero, dotted decimal address.
- Option 12 - Host Name.
Value is AVohhhhhh, where: o has one of the following values based on the OID (first
three octets) of the telephone’s MAC address: “A” if the OID is 00-04-0D, “B” if the OID
is 00-1B-4F, (SIP software Release 2.0+), “E” if the OID is 00-09-6E, “L” if the OID is
00-60-1D, “T” if the OID is 00-07-3B, (SIP software Release R2.0+) and “X” if the OID
TLSSRVR IP Address(es) or DNS name(s) of Avaya file server(s) used to
download configuration files.
Note: Transport Layer Security is used to authenticate the server.
VLANTEST Number of seconds to wait for a DHCPOFFER on a non-zero VLAN.
The default is 60 seconds.
Table 8: Parameters Set by DHCP (continued)
Parameter Description

Table of Contents

Related product manuals