Avaya one-X 1603SW - Page 81

Administering Options for the 1603SW-I SIP IP Deskphones
Issue 1 June 2010 81
RTCPMON " " (Null) RTCP Monitor IP or DNS address to be used as
destination for RTCP monitoring. Zero to 255 characters:
zero or one IP addresses in dotted decimal or DNS name
format. Note that this value is only set via SET command
in settings file if operating in a NON-Avaya environment,
otherwise this value is retrieved via PPM.
RTCPMONPERIOD 5 RTCP Monitor report period. Valid range = 5 - 30
Interval in seconds for sending out RTCP monitoring
reports.
RTCPMONPORT 5005 RTCP monitor port number. TCP/UDP port to be used as
destination port for RTCP monitoring. Valid range is
0-65535. Note that this value is only set via SET
command in settings file if operating in a NON-Avaya
environment, otherwise this value is retrieved via PPM.
RTP_PORT_LOW 5004 Specifies lower limit of a port range to be used by RTP/
RTCP or SRTP/SRTCP connections, for example, to
adapt to firewall traversal policies. Values: 1024-65503.
RTP_PORT_RANGE 40 Specifies the width of the port range to be used by RTP/
RTCP or SRTP/SRTCP connections, for example, to
adapt to firewall traversal policies. The upper limit is
calculated by the value of RTP_PORT_LOW plus the
value of RTP_PORT_RANGE, taking into consideration
the overall limit of 65535. Values: 32-64511.
SEND_DTMF_ TYPE 2 Defines whether DTMF tones are send in-band (regular
audio) or out-band (negotiation and transmission of
DTMF according to RFC 2833, with fallback to send
in-band DTMF tones, if far end does not support
RFC2833). Values are 1=in-band DTMF; 2=RFC2833
procedure.
SIG_PORT_LOW 1024 Lower limit of port range for signaling to support by the
phone. Values range from 1024 to 65503.
SIG_PORT_RANGE 64511 Port range for signaling to support by the phone. Values
range from 32 to 64511.
Table 11: 1603SW-I SIP IP Deskphones Customizeable System Parameters (continued)
Parameter Name Default
Value
Description and Value Range
8 of 10