Avaya Partner 18 - Programming a Caller ID Inspect Button

Using AT&TConnect
Programming a Caller ID Inspect Button
To program a Caller ID Inspect button:
✏
NOTE:
You can program a Caller ID Inspect button only if you have a
PARTNER II Release 3.0 or later system. Also, you cannot
program a Caller ID Inspect button while PassageWay
applications other than AT&TConnect are running.
1. Select Configure System . . . from the Setup menu.
The AT&TConnect Setup - System Configuration dialog box appears.
2.
Select the Continue button.
The AT&TConnect Setup - Caller ID inspect Feature dialog box
appears.
7-11