SZ; Reviewed:
SPOC 8/10/2007
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
13 of 30
ACM-Cisco-CM-GK.doc
3.4. Configuring Dial Plan and Caller ID on Avaya Communication
Manager
Uniform Dialing Plan (UDP) and Automated Alternate Routing (AAR) are used for the call
routing. The configurations in this section are for demonstration only.
Use the command display system-parameters customer-options to verify that Uniform Dialing
Plan is set to y.
display system-parameters customer-options Page 5 of 10
OPTIONAL FEATURES
Posted Messages? n Tenant Partitioning? n
PNC Duplication? n Terminal Trans. Init. (TTI)? n
Port Network Support? y Time of Day Routing? n
Uniform Dialing Plan? y
Processor and System MSP? n Usage Allocation Enhancements? y
Private Networking? y TN2501 VAL Maximum Capacity?
…
Use the command change dialplan analysis to configure the dial plan. The dialed digits 61xxx
(“x” is any digit) is configured as ext. Note the digits 61xxx match the extensions created on the
Cisco CallManager.
change dialplan analysis Page 1 of 12
DIAL PLAN ANALYSIS TABLE
Percent Full: 1
Dialed Total Call Dialed Total Call Dialed Total Call
String Length Type String Length Type String Length Type
1 3 dac
2 4 ext
61 5 ext
To Next Page
Loading...
