SZ; Reviewed:
SPOC 8/10/2007
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
9 of 30
ACM-Cisco-CM-GK.doc
Note that Codeset to Send Display must be configured to 0 in order for the Cisco GW to accept
the Q.931 call setup message from the Avaya Media Gateway.
add trunk-group 20 Page 2 of 21
Group Type: isdn
TRUNK PARAMETERS
Codeset to Send Display: 0 Codeset to Send National IEs: 6
Charge Advice: none
Supplementary Service Protocol: a Digit Handling (in/out): enbloc/enbloc
QSIG Value-Added? n
Digital Loss Group: 18
Incoming Calling Number - Delete: Insert: Format: unk-pvt
In order to support caller ID on the IP trunk (isdn type), configure Send Name and Send Calling
Number to y. In the sample configuration, the Format is configured to unk-pvt.
add trunk-group 20 Page 3 of 21
TRUNK FEATURES
ACA Assignment? n Measured: none
Internal Alert? n Maintenance Tests? y
Data Restriction? n NCA-TSC Trunk Member:
Send Name: y Send Calling Number: y
Used for DCS? n Send EMU Visitor CPN? n
Suppress # Outpulsing? n Format: unk-pvt
UUI IE Treatment: service-provider
Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Connected Number: n
Hold/Unhold Notifications? n
Send UUI IE? y Modify Tandem Calling Number? n
Send UCID? n
Send Codeset 6/7 LAI IE? y
To Next Page
Loading...
