SZ; Reviewed:
SPOC 8/10/2007
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
14 of 30
ACM-Cisco-CM-GK.doc
Use the command change aar analysis 6 (“6” is the first dialed digit) to configure the dialed
digits 61xxx to use aar and route pattern 20.
change aar analysis 6 Page 1 of 2
AAR DIGIT ANALYSIS TABLE
Percent Full: 1
Dialed Total Route Call Node ANI
String Min Max Pattern Type Num Reqd
61 5 5 20 aar n
…
Use the command change route-pattern 20 to set the trunk group 20 as a primary trunk group to
carry the calls to 61xxx. Since there are no digits deleted or inserted, all 5 digits will be used as
the called number. The Numbering Format is configured to lev0-pvt to support caller ID in the
sample configuration.
change route-pattern 20 Page 1 of 3
Pattern Number: 20 Pattern Name: cisco-GK
SCCAN? n Secure SIP? n
Grp FRL NPA Pfx Hop Toll No. Inserted DCS/ IXC
No Mrk Lmt List Del Digits QSIG
Dgts Intw
1: 20 0 n user
2: n user
3: n user
4: n user
5: n user
6: n user
BCC VALUE TSC CA-TSC ITC BCIE Service/Feature PARM No. Numbering LAR
0 1 2 3 4 W Request Dgts Format
Subaddress
1: y y y y y n n rest lev0-pvt none
2: y y y y y n n rest none
3: y y y y y n n rest none
In order to support caller ID for the private network, use the command display system-
parameters customer-options to verify that Private Networking is set to y.
display system-parameters customer-options Page 5 of 10
OPTIONAL FEATURES
Posted Messages? n Tenant Partitioning? n
PNC Duplication? n Terminal Trans. Init. (TTI)? y
Port Network Support? y Time of Day Routing? n
Uniform Dialing Plan? y
Processor and System MSP? n Usage Allocation Enhancements? y
Private Networking? y TN2501 VAL Maximum Capacity? n
…
To Next Page
Loading...
