SZ; Reviewed:
SPOC 8/10/2007
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
28 of 30
ACM-Cisco-CM-GK.doc
5. Verification Steps
The following are the verification steps:
• Use the commands status signaling-group 20 to check the signaling group is in service.
status signaling-group 20
STATUS SIGNALING GROUP
Group ID: 20 Active NCA-TSC Count: 0
Group Type: h.323 Active CA-TSC Count: 0
Signaling Type: facility associated signaling
Group State: in-service
• Make a call from extension 61000 (Cisco CallManager phone) to extension 4555 (Avaya
IP telephone). Use the command show gatekeeper call from the Cisco 2811 Gatekeeper
and verify that this is a gatekeeper controlled call. Note that bandwidth (BW) is shown 16
(Kbps), which is the VoIP call with G.729 codec. Also, the call is between two endpoints
extension 61000 and 4555 as shown below.
GateKeeper#show gatekeeper call
Total number of active calls = 1.
GATEKEEPER CALL INFO
====================
LocalCallID Age(secs) BW
542-195 6 16 (Kbps)
Endpt(s): Alias E.164Addr
src EP: Trunk-to-Gatekeeper_1 61000
CallSignalAddr Port R ASSignalAddr Port
60.1.1.5 54155 60.1.1.5 59507
Endpt(s): Alias E.164Addr
dst EP: 4555
CallSignalAddr Port RASSignalAddr Port
22.1.1.22 1720 22.1.1.22 1719
To Next Page
Loading...
